Graphite 58G874 Instruction Manual download pdf (Page 10)

TRANSLATION OF THE ORIGINAL INSTRUCTIONS

HAMMER DRILL

58G874

CAUTION: BEFORE USING THE POWER TOOL READ THIS MANUAL CAREFULLY AND KEEP IT FOR FUTURE

REFERENCE.

DETAILED SAFETY REGULATIONS

PRECAUTIONS FOR USING HAMMER DRILL

Caution: Unplug the power cord from the mains socket before commencing any activities related to

adjustment, repair or maintenance.

During hammer operation use protective glasses or goggles, ear protection and protective helmet (when ●

there is danger of falling objects). Use of protection half-mask and anti-slip boots is recommended. Use

dust extraction systems whenever required by the nature of the work performed.

Prior to operation ensure the drill chuck of the hammer is properly xed in its place. ●

During operation working tool may get loosened due to vibrations. Check carefully how the working ●

tool is xed prior to operation. Unwanted slack may cause tool damage or accident during operation.

If the hammer is to be operated at low temperature or after long storage, allow the hammer to operate ●

for few minutes without load, for its internal elements get properly lubricated.

When operating the hammer held high, stand rmly on the ground and ensure there are no bystanders ●

below.

Always hold the hammer with both hands, use additional handle. ●

Do not touch moving parts of the hammer. Do not stop rotating spindle of the hammer with your ●

hands. Such behaviour can cause hand injury.

Do not direct operating hammer at other persons or at yourself. ●

When operating the hammer, hold it by insulated parts to avoid electric shock in case of damaging live ●

electrical wire.

Do not allow any dust to get inside the hammer. Use mineral soap and damp cloth to clean hammer ●

surface. Do not use petrol or other cleaning agents that could damage plastic parts.

When use of extension cord is necessary always remember to use appropriate one (up to 15 m, section ●

1.5 mm

; between 15 and 40 m, section 2.5 mm

). Extension cord should be unwound whole.

Do not use three jaw drill chuck when the hammer drill is set to impact drilling or chiselling mode. This ●

chuck is designed only for regular drilling in wood or steel.

CAUTION! This device is designed to operate indoors.

The design is assumed to be safe, protection measures and additional safety systems are used,

nevertheless there is always a small risk of operational injuries.

CONSTRUCTION AND USE

Hammer drill is a hand-operated power tool with insulation class II. The tool is driven by single-phase

commutator motor. Hammer drill can be used for drilling holes in working mode with impact, digging

channels, or surface processing of materials such as concrete, stone, brick etc. Range of use covers repair

and building works, and any work from the range of individual, amateur activities (tinkering).

Use the power tool according to the manufacturer’s instructions only.

DESCRIPTION OF DRAWING PAGES

Below enumeration refers to the device elements depicted on the drawing pages of this manual.

SDS-MAX chuck1.

Fixing sleeve2.

Operation mode switch3.

Lid for greasing inlet4.

Switch5.

Voltage indicator lamp 6.

Bottom engine casing7.

Additional handle8.

* Dierences may appear between the product and drawing

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 87 88

Comments to this Manuals

No comments

Graphite 58G874 Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Rotary hammers Graphite 58G874